Disassembling The Top Cover And The Bottom Case Assembly - GRAPHTEC GL820 Service Manual

3.4 Disassembling the Top Cover and the Bottom Case Assembly

Disassembly
(1) Remove the input terminal unit from the main unit (See Section 3.3).
(2) Remove the side pads from the main unit (See Section 3.4).
(3) Remove the four M2L8 self-tapping screws from the bottom cover.
(4) Disconnect the connector between the main control board and the AMP board and then remove the top
cover assembly.
Top cover assembly
Bottom case assembly
Re-assembly
(1) Re-assemble the top cover assembly and the bottom case assembly in the reverse order in which they
were disassembled.
GL820-UM-251-9370
3. DISASSEMBLY AND REASSEMBLY
M2L8 self-tapping screw
3-4