Table of Contents
Advertisement
September 2016
Observe and Obey:
Troubleshooting and repair procedures shall be
completed by a person trained and qualified on
the repair of this machine.
Immediately tag and remove from service a
damaged or malfunctioning machine.
Repair any machine damage or malfunction
before operating the machine.
Part No. 40462
Troubleshooting Flow Charts
DPL-25S • DPL-30S • DPL-35S Super Series
Section 5 - Troubleshooting Flow Charts
Before Troubleshooting:
Read, understand and obey the safety rules and
operating instructions printed in the Genie DPL
Super Series Operator's Manual .
Be sure that all necessary tools and test
equipment are available and ready for use.
Read each appropiate flow chart thoroughly.
Attempting shortcuts may produce hazardous
conditions.
Be aware of the following hazards and follow
generally accepted safe workshop practices.
Electrocution/burn hazard. Contact
with electrically charged circuits
may result in death or serious
injury. Remove all rings, watches
and other jewelry.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to squirt
or spray.
Perform all troubleshooting on a
firm level surface.
Two persons will be required to
safely perform some
troubleshooting procedures.
5 - 1
Hide quick links:
Advertisement
Table of Contents
