Genie DPL-25S Service Manual page 45

Section 5 - Troubleshooting Flow Charts
CHART 5
Continued from the
previous page.
5 - 14
On the power unit,
remove and inspect the
N.O. valve for
contamination or damage.
Clean, repair or replace
valve and then perform
pressure test again.
less than 1800 psi
Adjust the pressure relief
valve. See Repair
procedure, How to Adjust
the Pressure Relief
Valve, and then perform
pressure test again.
less than 1800 psi
Consult Genie Industries
Service Department.
DPL-25S • DPL-30S • DPL-35S Super Series
September 2016
Part No. 40462