i3 International Ax45RM series User Manual page 48

6.10 Communication Setup
The Communication tab is used to
configure network and communication
settings on the camera as well as
camera OSD settings.
Note: Do not configure SNMP settings
in this tab as these are reserved
for development and advanced
troubleshooting by the manufacturer
only and are not required for normal
functioning of this camera
Network Settings:
•
DHCP: Set to Enabled or Disabled
to have the network automatically
assign an IP address to the camera.
•
IP Address: Enter the camera's IP
address here.
This option is disabled when DHCP
is enabled.
•
Subnet Mask: Enter the camera's
Subnet Mask here.
This option is disabled when DHCP
is enabled.
•
Default Gateway: Enter the IP address of the network's router if necessary.
Contact your network administrator for this information. This option is disabled
when DHCP is enabled.
•
DNS: Enter a DNS IP Address if necessary.
•
HTTP Port: Enter a HTTP Port number if necessary.
•
Physical Address: This field displays camera's MAC Address.
RTSP Settings:
•
Authentication: Enable to allow users to get the video stream using third party
players, such as VLC with the help or RTSP protocol.
UPnP Settings:
•
UPnP: Set to On or Off.
OSD Settings:
•
Basic Settings: Enable or disable camera's OSD settings.
»
OSD Camera Name: Turn Camera Name OSD On or Off. Camera Name is
configured in the Video setup tab.
»
OSD Date Time: Turn Camera Date/Time OSD On or Off. Camera date/time
settings are configured in the System setup tab.
i3-TRNG-CAMS-Ax45RM_65RM-UM.indd
48
Rev. 161107