Chapter 3.
Operation
3.1 Introduction
See Chapter 1, Installation, and Chapter 2, Initial Setup, to prepare the Model XMT868i system for operation. When
the meter is ready to take measurements, proceed with this chapter. The following specific topics are discussed:
•
Powering Up
•
Using the Display
•
Taking Measurements
•
Pausing Measurement
Note: All inputs and outputs of the Model XMT868i are calibrated at the factory, prior to shipment. If it becomes
necessary to recalibrate any of the inputs and/or outputs, see Chapter 1, Calibration, of the Service Manual for
instructions.
WARNING!
as described in this manual. In addition, be sure to follow all applicable local safety codes and
regulations for the installation of electrical equipment.
DigitalFlow™ XMT868i Startup Guide
To ensure the safe operation of the Model XMT868i, it must be installed and operated
Chapter 3. Operation
47