Changing The Mapping; Adjusting The Idle Speed - Husqvarna FC 250 2017 Owner's Manual

16 TUNING THE ENGINE
16.4

Changing the mapping

Info
The desired engine characteristic can be activated via the MAP button on the combination switch.
The setting most recently selected is activated again when restarting.
The traction control can also be activated in each mapping using the TC button.
The mapping can also be changed during the ride.
16.5

Adjusting the idle speed

Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation when running the engine.
–
Use an effective exhaust extraction system when starting or running the engine in an enclosed space.
Warning
Danger of accidents The engine may go out spontaneously if the idle speed is set too low.
–
Set the idle speed to the specified value. (Your authorized Husqvarna Motorcycles workshop will be glad to help.)
–
Position half-shells
Guideline
Screw, throttle grip
–
Slide on sleeve
F00095-10
Finishing work
–
Check the play in the throttle cable. (
Activating STANDARD mapping:
–
Press button MAP until LED1 lights up.
Guideline
Engine speed
STANDARD – balanced response
H01180-10
Activating ADVANCED mapping:
–
Press button MAP until LED2 lights up.
Guideline
Engine speed
ADVANCED – direct response
H01180-11

, mount and tighten screws
M6

and check the throttle grip for ease of movement.
p. 81)

.
5 Nm (3.7 lbf ft)
< 4,000 rpm
< 4,000 rpm
83