Storage; Putting Into Operation After Storage - Husqvarna FC 250 2017 Owner's Manual

19

STORAGE

19.1 Storage
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Avoid skin, eye and clothing contact with fuel.
–
Immediately consult a doctor if you swallow fuel.
–
Do not inhale fuel vapors.
–
In case of skin contact, rinse the affected area with plenty of water.
–
Rinse the eyes thoroughly with water, and consult a doctor in case of fuel contact with the eyes.
–
Change your clothing in case of fuel spills on them.
–
Keep fuels correctly in a suitable canister, and out of the reach of children.
Info
If you plan to garage the motorcycle for a longer period, perform the following steps or have them performed.
Before storing the motorcycle, check all parts for function and wear. If service, repairs, or replacements are necessary, you
should do this during the storage period (less workshop overload). In this way, you can avoid long workshop waiting times at
the start of the new season.
19.2

Putting into operation after storage

–
When refueling for the last time before taking the motorcycle out of service, add
fuel additive.
–
Refuel. (
–
Clean the motorcycle. (
–
Change the engine oil and oil filter, clean the oil screen.
–
Check the antifreeze and coolant level. (
–
Check the tire air pressure. (
–
Remove the battery.
401058-01
–
Recharge the battery.
Guideline
Storage temperature of battery with-
out direct sunshine
–
Store the vehicle in a dry location that is not subject to large fluctuations in tem-
perature.
Info
Husqvarna Motorcycles recommends raising the motorcycle.
–
Raise the motorcycle with a lift stand. (
–
Cover the vehicle with a tarp or similar cover that is permeable to air.
Info
Do not use non-porous materials since they prevent humidity from escap-
ing, thus causing corrosion.
Avoid running the engine for a short time only. Since the engine cannot
warm up properly, the water vapor produced during combustion con-
denses and causes valves and the exhaust system to rust.
–
Install the battery.
–
Remove the motorcycle from the lift stand. (
–
Perform checks and maintenance steps before putting into operation. (
–
Take a test ride.
401059-01
p. 24)
p. 90)
p. 72)
( p. 74)
( p. 75)
( p. 74)
( p. 87)
p. 78)
0... 35 °C (32... 95 °F)
p. 35)
p. 35)
91
p. 20)