Running In The Engine; Starting Power Of Lithium-Ion Batteries At Low Temperatures; Preparing The Vehicle For Difficult Riding Conditions - Husqvarna FC 250 2017 Owner's Manual

7 PREPARING FOR USE
–
Try also to ride as slowly as possible and in a standing position to get a better feeling for the motorcycle.
–
Do not make any off-road trips that exceed your ability and experience.
–
Hold the handlebar firmly with both hands and keep your feet on the footrests when riding.
–
Do not take luggage along.
–
Do not exceed the maximum permissible weight and the maximum permissible axle loads.
Guideline
Maximum permissible overall weight
Maximum permissible front axle load
Maximum permissible rear axle load
–
Run in the engine. ( p. 17)
7.2

Running in the engine

–
During the running-in phase, do not exceed the specified engine speed and engine performance.
Guideline
Maximum engine speed
During the first operating hour
Maximum engine performance
During the first 3 operating hours
–
Avoid fully opening the throttle!
7.3

Starting power of lithium-ion batteries at low temperatures

7.4

Preparing the vehicle for difficult riding conditions

Info
Use of the vehicle under difficult conditions, such as on sand or on wet and muddy surfaces, can lead to considerably more
rapid wear of components such as the drive train, brake system, or suspension components. For this reason, it may be nec-
essary to inspect or replace parts before the next scheduled service.
–
Clean the air filter and air filter box.
Info
Check the air filter approx. every 30 minutes.
–
Check the electrical connector for humidity and corrosion and to ensure it is firmly seated.
» If humidity, corrosion, or damage is found:
–
Clean and dry the connector, or change it if necessary.
Difficult riding conditions are:
–
Rides on dry sand. (
–
Rides on wet sand. (
–
Rides on wet and muddy surfaces. (
–
Rides at high temperatures and low speeds. (
–
Riding at low temperature and in snow. (
Lithium-ion batteries are far lighter than lead batteries, have a low self-discharge rate,
and have more starting power at temperatures over 15 °C (60 °F). At low tempera-
tures, however, the starting power of lithium-ion batteries drops to below that of lead
batteries.
Multiple starting attempts may be needed. Press the electric starter button for 5 sec-
onds, and wait 30 seconds between attempts. The pauses are necessary so that the
created heat can distribute through the lithium-ion battery and the battery is not dam-
aged.
If the charged lithium-ion battery does not or only weakly turns over the electric
starter when temperatures are below 15 °C (60 °F), then the battery is not faulty, but
402555-01
needs to be warmed up internally to increase its starting power (current output).
The starting power increases as the battery warms up.
( p. 47)
p. 18)
p. 18)
p. 19)
p. 19)
p. 19)
335 kg (739 lb.)
145 kg (320 lb.)
190 kg (419 lb.)
7,000 rpm
≤ 75 %
17