11
SERVICE WORK ON THE CHASSIS
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
F00057-10
–
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 (
–
Mount bleeding syringe
–
Only loosen bleeder screw
ing is possible.
Info
F00083-10
Clean up overflowed or spilled brake fluid immediately with water.
Avoid contact between brake fluid and painted parts. Brake fluid attacks
paint.
Only use clean brake fluid from a sealed container.
–
Inject the liquid into the system only until it emerges from drill hole
master cylinder without bubbles.
–
Now and then, extract fluid from the master cylinder reservoir to prevent overflow.
–
Tighten the bleeder screw and remove the bleeding syringe with the hose.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
–
Position the cover with the membrane. Mount and tighten the screws.
F00058-10
.
with membrane
.
with the appropriate hydraulic fluid.
p. 102)
on bleeder screw
on the clutch slave cylinder to the point where fill-
using a fitting section of hose.
4 mm (0.16 in)
59
of the