Husqvarna FC 250 2017 Owner's Manual page 70

12 BRAKE SYSTEM
–
Stand the vehicle upright.
–
Remove screw cap
E00267-10
–
Manually press the brake caliper to the brake disc to push back the brake piston.
Ensure that brake fluid does not flow out of the brake fluid reservoir, extracting it
by suction if it does.
Info
Make sure when pushing back the brake piston that you do not press the
brake caliper against the spokes.
–
Remove cotter pins
–
Clean the brake caliper and brake caliper support.
H00324-10
–
Check that leaf spring
caliper support are seated correctly.
Info
The arrow on the leaf spring points in the rotation direction of the brake
disc.
H00326-10
–
Insert the new brake linings, insert pin
Info
Always change the brake linings in pairs.
Make sure that decoupling plate
lining.
–
Operate the foot brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
H00327-10
–
Add brake fluid to level
Brake fluid DOT 4 (
–
Mount and tighten screw cap
Info
Clean up overflowed or spilled brake fluid immediately with water.
F00085-10
 
with membrane and the O-ring.
 
, pull out pin , and remove the brake linings.

in the brake caliper and sliding plate

, and mount cotter pins

is mounted on the piston side brake

.
p. 102)

with membrane

in the brake

.

and the O-ring.
68