Removing The Lower Triple Clamp; Installing The Lower Triple Clamp - Husqvarna FC 250 2017 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.9

Removing the lower triple clamp

11.10

Installing the lower triple clamp

Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove the start number plate. (
–
Remove the front fender. (
–
Remove the handlebar cushion.
Main work
–
Remove the holder with FI warning lamp.
–
Open cable holder
–
Remove screw
–
Remove screw
–
Take off the upper triple clamp with the handlebar and set it aside.
Info
Cover the components to protect them against damage.
F00055-10
Do not kink the cables and lines.
–
Remove O-ring
–
Take off the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
B01865-10
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering
head bearing.
–
Check whether upper steering head seal
–
Slide on protective ring
102146-10
p. 35)
( p. 69)
( p. 37)
p. 41)
p. 42)

on the left and detach the wiring harness.

.

.

. Remove protective ring
p. 104)

 
and O-ring

.
is correctly positioned.
.
38