SMC Networks HRS012-A Operation Manual page 25

Contact output 3 selected alarm Setting and checking
35.
Press the [SEL] key once.
The set screen of contact output 3 selected alarm is displayed on the digital display.
PV
SV
36.
Select contact output 3 selected alarm from the table below with [▲] key or [▼] key, and
confirm by pressing "SEL".
Set values
to
Communication mode Setting and checking
37.
Press the [SEL] key once.
The set screen of communication mode is displayed on the digital display.
PV
SV
38.
Select communication mode【DIO】from the table below with [▲] key or [▼] key, and
confirm by pressing "SEL".
Set value
HRS Series
Table 2.4-19 List of set values
Explanation
Setting/checking are not available unless the
function setting of contact output 1 is selected
alarm status signal.
Sets selection alarm.
Set range is AL.01 to AL.36.
Table 2.4-20
Explanation
Sets LOCAL mode.
Sets DIO mode.
Sets SERIAL mode.
Chapter 2 Contact input/output communication
List of set values
HRX-OM-M091
Initial value
(Default setting)
Initial value
(Default setting)
○
2.4 Setting and checking
2-15