SMC Networks HRS012-A Operation Manual page 22

HRX-OM-M091
Chapter 2 Contact input/output communication
26.
Select contact output 2 function from the table below with [▲] key or [▼] key, and confirm
by pressing "SEL".
Set values
Contact output 2 operation Setting and checking
27.
Press the [SEL] key once.
The set screen of contact output 2 operation is displayed on the digital display.
PV
SV
28.
Select contact output 2 operation from the table below with [▲] key or [▼] key, and confirm
by pressing "SEL".
Set values
2.4 Setting and checking
2-12
Table 2.4-14 List of set values
Explanation
Without output signal
Signal of operating status is output
Signal of remote status is output
Signal for completion of preparation (TEMP
READY)
Signal for the status of the operation stop alarm
is output
Signal for the status of the operation continue
alarm is output
Signal for the alarm status is output
Signal for selected alarm status is output
Signal for Run timer set status is output
Signal for Stop timer set status is output
Signal for the recovery from power failure is
output
Signal for anti-freezing setting is output
Pass through signal of contact input signal 1
Pass through signal of contact input signal 2
Signal output during automatic fluid filling
Table 2.4-15 List of set values
Explanation
N.O type
N.C type
Initial value
(Default setting)
○
Initial value
(Default setting)
○
HRS Series