Datamax I-class series Operator's Manual page 47

Communications (continued)
Menu Item
WLAN ADHOC?
CANCEL KEY = YES
SET FACTORY DEFAULTS
SET DEFAULTS?
CANCEL KEY = YES
WLAN
MODE
ENABLED
DISABLED
BSS ADDRESS
 192.168.010.001
SIGNAL READINGS
IP ADDRESS
192.168.010.026
SUBNET MASK
255.255.255.000
GATEWAY
192.168.010.026
I-Class
Restores the WiFi defaults and initiates infrastructure
mode with an SSID of "Any." All existing access point
associations will be deleted then established with the
closest available. (Useful when moving the printer to a
geographically distant location.)
Note: Press the ESC Key to exit the menu item

without changing the current settings.
Returns the factory-programmed values, where:
Restores the default settings.
Note: Press the ESC Key to exit the menu item

without changing the current settings.
Controls the communications settings for the optional
DMXrfNetII Card, where:
Selects between Wired or WiFi operation, where:
Enables the WiFi interface.
Enables the Wired interface.
Specifies the WiFi bridge module's static IP address.
Note: If DHCP is ENABLED, this parameter will be

ignored.
Is the address in standard octet format.
Displays the signal and noise ratios for the WLAN.
Specifies the static IP Address; where:
Is the address in standard octet format.
Specifies the static Subnet Mask Address, where:
Is the address in standard octet format.
Specifies the network Gateway Address, where:
Is the address in standard octet format.
Details