Datamax I-class series Operator's Manual page 10

3
Setting up the Printer
3.1 Installation
Interface and connect power to the printer:
A. Place the printer on a firm, level surface.
B. Turn OFF the Host Computer then, depending upon your system, connect an appropriate
interface cable from the host to the printer; see Section 3.1.1.
C. Turn ON the Host Computer.
D. Ensure that the printer's Power On/Off Switch is in the OFF position. Connect the AC
Power Cord to the AC Power Connector, and then plug the AC Power Cord into a properly
grounded AC Outlet.
Note: When interfacing, ensure AC power has been turned OFF, and always apply

power to the Host before the Printer.
I-Class