Datamax I-class series Operator's Manual page 25

Media Settings (continued)
Menu Item
PAUSE ON RIBBON LOW
ENABLED
DISABLED
SENSOR CALIBRATION
PERFORM CALIBRATION
ADVANCED ENTRY
SENSOR LEVELS
SENSOR GAIN
PRINTHEAD CLEANING
CLEAN HEAD SCHEDULE
000 in. (* 1000)
CLEAN HEAD COUNTER
RESET COUNTER
CLEAN HEAD NOW
I-Class
Sets the printer to pause when the RIBBON LOW
DIAMETER setting is met, where:
Forces the user to press the PAUSE Key to proceed with
the print job.
Allows printing to continue until ribbon empty is
declared.
Selects the method used to calibrate the media sensor
(see Section 5.2), where:
Sets the values via printer calculations.
Sets the values via manual entry, where:
Allows manual entry of paper, gap (or mark), and
empty threshold values.
Adjusts the sensor sensitivity.
Controls the automatic cleaning alert and function,
where:
Specifies the amount of media (times one thousand)
that can be used before a print head cleaning warning
will be issued (If exceeded three times, however, a
fault will be declared.)
Note: Zero (000) disables this function.

Indicates the number of inches (or cm) since cleaning
was last initiated.
Resets the Clean Head Counter to zero to restart the
Clean Head Schedule.
Initiates the cleaning process then resets the Clean
Head Counter. Remove ribbon. Also see Section 5.6.1.
Details