Drive Belt - Can-Am MAVERICK X3 Series 2017 Operator's Manual

MAINTENANCE PROCEDURES
CVT Cover Removal
Loosen CVT inlet hose clamp(s).
219001761-051_a
1. Clamp
Use wrench supplied in tool kit to re-
move the thirteen CVT cover screws.
Remove the center top screw last to
support the cover during removal.
NOTICE
Do not use an impact tool
to remove CVT cover screws.
Remove the CVT cover and its gasket.
219001761-138_a
1. CVT cover screws
2. CVT cover
3. Gasket
Check inside front and rear CVT outlet
hoses to make sure there are no de-
bris.
CVT Cover Installation
Install the center top screw of first.
Tighten the CVT cover screws as per
following sequence.
______________
96
219001761-113_a
TIGHTENING TORQUE
CVT Cover
screws

Drive Belt

Drive Belt Removal
NOTICE
In case of a drive belt fail-
ure, the CVT, cover and air outlet
must be cleaned.
TIPS FOR MAXIMIZING
Please refer to
DRIVE BELT DURABILITY
IMPORTANT information.
CVT COVER
Remove
Open driven pulley.
REQUIRED TOOLS
PULLER/LOCKING
TOOL (P/N 529
000 088)
(supplied in tool kit)
DRIVEN PULLEY
ADAPTER
(P/N 708 200 720)
(supplied in tool kit)
Insert the pulley adaptor in the driven
pulley threaded hole, then screw it in.
Insert the puller/locking tool in the pul-
ley adaptor threaded hole, then screw
it in to open the pulley.
7 N•m ± 0.8 N•m
(62 lbf•in ± 7 lbf•in)
for some
.