How To Disassemble The Gl - Models Equipped With An Electric Winch; Electrocution/Burn Hazard - Genie Lift Service Manual

Service Manual
Base Assembly
1-2 1-2 H ow to Disas sem ble the GL - M odels Equi pped with an El ectric Winch
How to Disassemble the Winch
1 Remove the load handling attachment from
the carriage.
2 Fully lower the carriage
3 Disconnect the battery from the machine.

Electrocution/burn hazard.

Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
4 Remove the battery and battery charger from
the machine.
Models with counterweight base:
5 Support the base counterweights with a
proper lifting device.
6 Remove the counterweight retaining fasteners
from the base and remove the counterweight
from the base.
All models:
7 Using proper lifting techniques, lay the
machine over onto a table or other suitable
work surface.
8 Remove the legs from the machine.
32
9 GL-4 models: Remove the cable mounting
fastener from the handle bracket.
GL-8, GL-10 and GL-12 models: Remove
the cable mounting fastener from the upper
inner frame casting.
10 Remove the mounting fasteners from the
electric winch cover.
11 Tag and disconnect the wiring from the electric
winch cover and remove the electric winch
cover from the machine.
12 Remove the old cable following instructions in
the Owner's Manual for Rule Winches (Rule
part number W-1013).
Owner Manual for Rule Winches
Genie part number
Remove the base mounting fasteners from the
outer frame channels and remove the base from
the machine.
13 Remove the limit switch mounting fasteners
and remove the limit switch from the machine.
14 GL-4 models: Remove the carriage from the
outer frame. Proceed to step 21.
Note: After removing the carriage, note the location
of the roller wheel buttons, on the carriage roller
wheels.
Genie Lift
September 2016
Bodily injury hazard. Cables can
fray. Always wear adequate
hand protection when handling
cable.
Part No. 115417
85220