Table of Contents
Advertisement
Service Manual
Base Assembly
9
Remove the legs from the base.
10 Remove the base mounting fasteners from the
outer frame channels. Then remove the base
from the machine.
11 GL-8, GL-10, GL-12: Slide the inner frame
out the bottom of the outer frame
approximately6 inches / 15 cm.
12 Use a soft metal drift to remove the glide
button.
13 Press the new glide button in place until it is
fully seated.
40
1-8
1-8 H ow to Adjus t the Brak e (if equi pped)
How to Adjust the Brake
(if equipped)
Note: Refer to the illustration,
Assembly (option)
1
Rotate the brake pedal to the up or unlocked
position.
2
Loosen the clamping bolts from all three of the
brake cams.
3
Rotate both of the wheel-brake cams until they
contact the tires. Tighten the brake cam
clamping bolts.
4
With the pedal up, rotate the brake cam rod
until there is approximately 1/4 inch of gap
between the wheel and the wheel-brake
cam. Tighten the center brake cam clamping
bolt.
5
Check the brake for proper activation.
Note: Apply enough force to the brake pedal to lock
the brakes in place. After the brakes are engaged,
the brakes should hold the wheels in place with
enough force to keep the wheels from turning.
Genie Lift
September 2016
Rear Wheel Brake
, for an exploded view.
Part No. 115417
Hide quick links:
Advertisement
Table of Contents
