September 2016
C-2
C-2 Repl ace the Manual Wi nch Friction Disk s
Inspect the Safety Brake System
(if equipped)
Genie specifications require that this procedure be
performed every 1000 hours or annually,
whichever comes first.
Maintaining the winch is essential to good machine
performance and safe operation. An unsafe
working condition exists if the winch has excessive
wear and/or does not operate smoothly, free of
hesitation and binding.
1
Replace the winch brake disks and lubricate
the winch shaft. Refer to Repair Procedure,
How to Disassemble the Manual Winch
Part No. 115417
Checklist C Procedures
C-3
C-3 Inspec t the Pai nted Surfac es
Inspect the Painted Surfaces
Genie specifications require that this procedure be
performed every 1000 hours or annually,
whichever comes first.
Inspecting the painted surfaces of your machine is
essential to safe operation and long machine
life. An unsafe working condition exists if there is
damage to painted surfaces that is not corrected.
1
Visually inspect all painted surfaces for the
following conditions:
• Blistering
• Rust
• Peeling
.
• Fading
• Corrosion
Note: Replace any component that is damaged.
Genie Lift
Service Manual
29