How To Replace The Lifting Pulley; How To Replace The Lifting Cable - Genie Lift Service Manual

September 2016
1-5 1-5 H ow to Replace the Lifting Pulley

How to Replace the Lifting Pulley

1 Fully lower the carriage.
2 Unwind the cable from the winch drum. Do
not remove the cable.
Bodily injury hazard. Cables can
fray. Always wear adequate
hand protection when handling
cable.
3 Remove the pulley mounting fastener and
remove the pulley from the machine.
4 Wrap the cable around the new pulley and
install the pulley on to the machine.
Note: Be sure not to twist the cable when installing
the new pulley.
Part No. 115417
1-6 H ow to Replace the Lifting C abl e 1-6

How to Replace the Lifting Cable

Models with manual winch:
1 Fully lower the carriage.
2 Remove the jam nut from the winch drum bolt
and remove the winch drum cover.
3 Remove the cable retaining fastener from the
winch drum and unwind the cable from the
winch drum.
The numbers on the illustration correspond to the
steps in Repair Procedure,
Lifting Cable
.
9
Genie Lift
Service Manual
Base Assembly
How to Replace the
9
7
10
6
8
5
GL-8, GL-10
and GL12
10
Cable slot
Carriage is raised
6
for illustrative
purpose only
GL-4
5
Cable slot
37