LifeSpan DT5 Owner's Manual page 13

DT7 Desk:
Desk Leveling and Height Adjustment
Desk Leveling
The desk needs to be leveled
prior to use. The desk comes
with two Adjustable Feet that
can be used to level the desk
and eliminate rocking. If the
desk is rocking on two of the
feet, adjust the two front feet
until all four feet are sitting
securely on the floor.
Desk Height Adjustment
A. To raise the desk, press the
up or down arrow until the
desk is at the desired height.
B. To save a height press and
hold the memory preset,
one or two, button for three
seconds. This will save the
current height into memory.
C. The next time the desk
is used, simply press the
memory preset to adjust
the desk height to the
previously saved setting.
24
Desk Adjustment Feet
Desk Height
Preset
1 2
Desk Height Memory Pre-Sets
DT7 Electric Treadmill Desk:
Treadmill to DT5 Desk Assembly
A. Position the pre-assembled treadmill as shown below.
B. Lift the rear of the treadmill and roll it forward under the desk until the
Positioning Bumpers (D) located on the treadmill are centered over the
Treadmill Position Bumper (A) at the base of the uprights.
Roll Forward
Lift
D
C. Plug the Console Connector from the desk into the Treadmill Console Port
and tighten the thumb screws on the connector.
D. Plug the Power Cord into the Treadmill Power Receptacle and turn
the Power Switch on. Be sure all connectors are plugged in prior to
connecting the Power Cord.
Power Switch
Power Receptacle
Console Port
Console Connector
Assembly Instructions
D
A
25