LifeSpan DT-5 Owner's Manual
Tandem desk
Hide thumbs
Also See for DT-5:
- Owner's manual (34 pages) ,
- Quick start (2 pages) ,
- Owner's manual (16 pages)
Advertisement
At LifeSpan we strive to make our equipment easy to assemble and start using. Parts that can be
pre-assembled are always assembled and tested on the production line
Prior to starting the assembly process take all of the parts out of the box, remove plastic bags and lay the
parts out on the floor to become familiar with the components.
Since this desk can be heavy, it is recommended that you use two people during assembly and follow these
assembly instructions to reduce any problems that could occur.
For Warranty, Limitations and Exclusions please refer to your DT-5 or DT-7 Owner's Manual.
The Maximum Load Capacity of this desk is 300 lbs. (136 kg)
Item Number
Description
1
Lift Frame Upright
2
Support Bracket
3
Desktop
4
Leg
5
M8*10L Bolt
6
M8 Washer
7
M8*16L Bolt
8
M8*45L Carriage Bolt
9
M8 Lock Nut
10
Set Screw
Tandem Desk:
Assembly Instructions
1
(Pre-installed)
(Pre-installed)
(Pre-installed)
(Pre-installed)
8
2
9
6
5
6
Included in Hardware Bag
M8*10L Bolt
M8 Washer
3
7
Wrench-13mm
Allen Wrench-5mm
4
Advertisement
Table of Contents
Related Manuals for LifeSpan DT-5
Summary of Contents for LifeSpan DT-5
- Page 1 Tandem Desk: Assembly Instructions At LifeSpan we strive to make our equipment easy to assemble and start using. Parts that can be pre-assembled are always assembled and tested on the production line Prior to starting the assembly process take all of the parts out of the box, remove plastic bags and lay the parts out on the floor to become familiar with the components.
- Page 2 (1) from the side of the desk you are assembling the Tandem Desk to. B. Attach the support bracket (2) to the DT-5 or DT-7 lift frame upright (1) with the three M8*10L bolts (5) and M8 washers (6) found in the hardware bag.
- Page 3 Tandem X Desk: Assembly Instructions At LifeSpan we strive to make our equipment easy to assemble and start using. Parts that can be pre-assembled are always assembled and tested on the production line Prior to starting the assembly process take all of the parts out of the box, remove plastic bags and lay the parts out on the floor to become familiar with the components.
- Page 4 The expansion desk comes from the factory set up to work on the left side of the DT-5 or DT-7 Desk. If the Tandem desk is set up on the right side of the DT-5 or DT-7 simply remove the six screws from the bottom of the desk frame and turn the frame 180 degrees.
Need help?
Do you have a question about the DT-5 and is the answer not in the manual?
Questions and answers