Collate Copy - Panasonic DP-MB500 series Operating Instructions Manual

7.3.3 Collate copy

The unit can collate multiple copies in the same order as the original document pages.
Example: Making 2 copies of a 4-page original document
Collated pages
1
4
3
2
1
1.
Set the original.
2.
: /COPY
: Display "Settings" screen (page 86).
3.
Select "ON"
4.
Enter the number of copies (up to 99).
5.
/START
When using the scanner glass, scan the 1st page.
: To scan the next page, place the document and press OK/SET . Repeat this until all the
documents are scanned, then press
: To scan the next page, place the document and press "Scan". Repeat this until all the documents
are scanned, then press "Start".
Note
• After you finish copying, press
• The unit will store the documents into memory at a reduced resolution while collating the copies. If the
memory becomes full while storing, the unit will only print out the stored pages.
• You can hold the previous collate setting (feature #469).
Proof set feature (automatic document feeder only) (
If you activate this feature, the unit will make 1 set of a collated copy and stop temporarily so you can check
whether the copy was made as you expected.
1.
Set the original.
2.
: /COPY
: Display "Settings" screen (page 86).
3.
Select "PROOF SET"
4. Enter the number of copies (up to 99).
5.
/START
• The unit will make 1 set of a collated copy.
6.
If the copy is correct, press
If the copy is not correct, press
beginning.
4
3
2
: "COLLATE"
: OK/SET / :
/START .
: /STOP /
: "COLLATE"
: OK/SET /
: /START /
: /STOP /
Uncollated pages
4
4
3
3
2
2
1
1
"COLLATE"
: to reset this feature.
)
"COLLATE"
:
: "Continue" to continue copying.
: "Cancel" and start again from the
7.3.3 Collate copy
Operating Instructions 91