Panasonic DP-MB500 series Operating Instructions Manual page 152

11.2 General messages
Display
"RX MEMORY FULL"
"SLEEP"
"TONER EMPTY"
"TONER LOW"
"TRANSMIT ERROR"
"USB HUB NOT
SUPPORTED"
"USB MEMORY ACCESS
ERROR"
"USB MEMORY FILE
SIZE OVER"
"USB MEMORY FORMAT
ERROR"
"USB MEMORY MEDIA
ERROR"
"USB MEMORY NO
RESPONSE"
"USB MEMORY NOT
INSERTED"
"USB MEMORY
UNSUPPORTED"
152 Operating Instructions
Cause & Solution
• The memory is full of received documents due to a lack of recording paper or a
recording paper jam. Load paper (page 36) or remove the jammed paper
(page 174).
• If the PC fax (feature #442) is set to "ALWAYS",
– check the connection between the computer and the unit.
– check that the computer is turned on.
• If the fax preview mode (feature #448) is set to "ON",
– view, print or save the received fax documents using the web browser on the
computer connected via the LAN, and then erase the unnecessary
documents (page 118).
– turn the setting to "OFF". The fax documents stored in memory will be
printed automatically.
• After the unit has been in power save mode (feature #403) for up to 5 minutes,
the unit will enter sleep mode. Press any key to put the unit in standby for the
next process.
Note
• The unit may not enter sleep mode when beeping for alert or displaying an
error message.
• The toner is empty. Replace the toner cartridge immediately.
• The toner is reaching the end of its life. You will need to replace the toner
cartridge soon.
• A transmission error occurred. Try again.
• USB hubs are not supported. Do not connect via a USB hub.
• The USB memory device was removed while being accessed for reading/
writing. Insert the device and reperform the operation.
• A fault occurred while the USB memory device was being accessed for
reading/writing. Using a computer, check that the device can be read and
written to normally.
• There is no space to save new data on the USB memory device. Erase
unnecessary data using your computer.
• When performing scan to USB memory, the total number of scanned pages
has exceeded the limitation. Divide the document into sections.
• The media is unformatted or is formatted to an unsupported format (e.g.,
NTFS). Using a computer, format to FAT32. Formatting deletes all data on the
USB memory device. Make sure to back up your data before formatting.
• An unsupported USB memory device is connected. Devices with particular
security features or hub features cannot be used.
• The USB memory device is not responding. Use another USB memory device.
• The USB memory device has been removed from the unit. Reinsert it.
• There is no USB memory device inserted in the unit. Insert one.
• A device other than a USB memory device is inserted. Do not connect
unsupported devices.