Panasonic DP-MB500 series Operating Instructions Manual page 125

Feature Code
Memory reception #437
alert
Friendly reception #438
Input tray setting #440
for fax
PC fax setting #442
PC fax reception #443
Fax preview mode #448
Web fax preview #450
access code
Description
To alert you with a beeping sound when a received fax
document is stored into memory.
Note
• If documents are stored into memory due to some
printing problem, the beeps will continue until you solve
the problem. If a message is displayed, see page 149
for directions on printing out the stored documents.
Make sure the unit is supplied with enough paper to
print the stored document.
• If documents are stored into memory due to activating
the web fax preview (feature #448), the unit will not
beep. However, the unit will start to beep when the
memory is nearly full (LAN supported models only).
( )
To receive a fax automatically when you answer a call and
hear a fax calling tone (slow beep). When this feature is
activated, you do not have to press
: 2 / : "Receive" for fax reception.
To set the input tray to use for fax.
If you wish to receive a fax to a computer, activate this
feature and run [PC FAX] from Multi-Function Station.
This feature is available only when the fax preview mode is
turned OFF (feature #448) (LAN supported models only).
( )
• "OFF": Deactivates this feature.
• "ALWAYS": If the unit recognizes the connection to the
computer, it will transfer received documents to the
computer. If the unit cannot recognize the connection, it
will store received documents into memory, and then
transfer the data after recognition of the computer
connection.
• "CONNECTED": If the unit recognizes the connection to the
computer, it will transfer received documents to the
computer. If the unit cannot recognize the connection, it
will print the data.
To select the computer that will be used for receiving a fax.
See page 117 for details.
To set the fax preview mode. See page 118 for details.
To set the web fax preview access code. After entering the
programming password (feature #155), enter the access
code (up to 8 characters, using the English alphabet and
numbers).
• The following symbols can also be entered (page 59).
! @ # $ % ^ & ' ) ( . - _ { }
8.9 Programming features: Fax
Default
key
/START , and then
Operating Instructions
1
1
1
–
–
0
–
125