Seagate NAS OS 4 U User Manual page 117

.Important : Data stored on the volume is deleted when changing RAID levels
Review the summary page and then choose Finish. A popup window cautions you that all data on the .7
.On the Storage section at the lower left, choose the JBOD volume you want to expand .1
In the Select disks window, hard drives with white checkboxes can be selected for the existing volume. Hard .4
drives with grey checkboxes are being used by volumes and cannot be selected. Select the boxes under
Review the summary page and then choose Finish. A popup window cautions you that all data on the .5
Protected volumes: Expansion and hard drive
Removing healthy hard drives from a protected
117
.the hard drives that you want to add to the existing volume and choose Next
.Important : All data on the selected hard drives is deleted
.Increase security to enable protection on the RAID 1 volume
.selected hard drives will be deleted. Choose Yes to continue
.the hard drives that you want to add to the existing volume and choose Next
.Important : All data on the selected hard drives is deleted
.selected hard drives will be deleted. Choose Yes to continue
10/18/16
.Custom to change the RAID to SimplyRAID
.You can use the volume during the RAID synchronization
(SimplyRAID (single-disk or double-disk security
(RAID 1/RAID 1+Spare (two hard drives minimum

:Select one of the following .5

.Choose Next .6
.Choose Manage .2
.Choose Add drive and Next .3

replacement
volume
:A protected volume can be
RAID 5/RAID 5+Spare
RAID 6/RAID 6+Spare
RAID 10/RAID 10+Spare
Seagate NAS OS 4
JBOD