Next Steps30 - Seagate NAS OS 4 U User Manual

.Power on your Seagate NAS device. The device is ready to be accessed once the status LED turns solid .1
From a PC/Mac connected to the same network as your NAS, launch an Internet browser and type .2
http://discover.seagate.com
Follow the on-screen instructions. The setup formats the drives and installs NAS OS. During the installation, .3
:you can
.Create or change the name of the device
( . Create or change the administrator login (the default is admin
.Create a Seagate Access account for remote access
.Configure or change the RAID level
.Adjust the time zone
Make certain to note your login and password for future use. Upon completion, you are prompted to restart the
.NAS
Note on USB keys: If your Seagate NAS requires a USB key to boot to the NAS OS installer, you

must remove the USB key before rebooting the device. The NAS will use the USB key as the boot disk
.if it is not removed
Upon reboot, the status LED turns on and begins to blink. The device is ready to be accessed once
.the status LED has turned solid and the welcome page appears on the NAS Setup Wizard
Next steps
Simplify NAS access: Seagate recommends that you install the software utility Seagate Network Assistant
before moving forward with the device configuration. Seagate Network Assistant gives you instant
information on your Seagate NAS, such as firmware version, IP address, and MAC address. It will also
.provide quick access to shares and NAS OS. See Seagate Network Assistant for instructions
Configure your NAS: For details on how to configure and use your Seagate NAS, go to Shares: Access and
30 10/18/16 Seagate NAS OS 4