Ventilation And Waste-Collection Requirements; Computer And Network Requirements - AB Sciex 4000 Series Site Planning Manual

Ventilation and Waste-Collection Requirements

Refer to Ventilation and Waste Collection Requirements on page
Requirement
Installation of plumbing and ventilation fixtures complies with local biohazard regulations and
safety standards.
Ventilation of the laboratory environment in which the mass spectrometer will be used complies
with local regulations and the air exchange rate is appropriate for the work performed.
A negative flow vent is provided with a total flow rate capacity of 283 L/min (10 cfm), as measured
at the inlet to the laboratory ventilation system.
A smooth fitting is provided for the roughing pump, with an outside diameter (o.d.) of 3.2 cm
(1.25 inches). The vent is within 1.5 m (60 inches) of the exhaust port on the roughing pump and
at least 1 m (40 inches) above the floor.
A fitting is provided for the source exhaust drain bottle with an o.d. of 1.3 cm (0.5 inch). The vent
is within 1.5 m (60 inches) of the source exhaust drain bottle.

Computer and Network Requirements

Refer to Computer and Network Requirements on page
Requirement
A table is provided for the data acquisition workstation, located within 3 m (120 inches) of
the mass spectrometer.
A computer name and password are available.
(Optional) A network or IT specialist is available to install the security software while the
FSE is present.
A network printer or a dedicated printer and necessary print drivers are available.
(Optional) An active, tested LAN connection is available.
(Optional) The computer name and password supplied are a network computer name and
domain password.
(Optional) A network or IT specialist is available to connect the computer to the company
LAN while the FSE is present.
Site Planning Guide
RUO-IDV-01-0563-A | D5040008 A
Site Planning Checklist
25.
27.
AB SCIEX 4000 Series of Instruments
Complete
Complete N/A
11 of 33