Setting The Network Adapter; Setting The Ip Address - InfraTec VARIOCAM HD User Manual

10.2.1 Setting the network adapter

Fig. 203 Selection of the LAN connection
Upon opening the "Network and Sharing Center", the "Change adapter settings" menu item can be
selected. In this menu item, the network card to be used must be highlighted and its properties must be
opened by using the right mouse button.

10.2.2 Setting the IP address

Before configuring the network card for being used in connection with the camera, the properties of the
interface card to be used must be checked. In this, releasing non essential functionalities and assigning a
fixed IP address are important. The screenshots shown below provide an overview:
Fig. 204 Properties of the LAN connection
Please note that you only need the components described above in order to establish an Ethernet
connection to the VarioCAM
contained in the input mask.
86
®
HD. Therefore, we recommend deactivating any further components
© InfraTec GmbH 2016
Thermography System VarioCAM
10. Introduction
User Manual
® HD