Hardware Installation - Planet ICA-M3380P User Manual

1. The low voltage/current circuits and high voltage/current circuits are in the
network camera circuit. Only a qualified electrician should do the wiring not
by yourself. Incorrect wiring could damage the network camera and you
might get a fatal electric shock.
2. The external I/O is not capable of connecting directly to devices that require
large amounts of current. In some cases, a custom interface circuit (customer
provided) may have to be used. Serious damage to the network camera may
result if a device is connected to the external I/O that exceeds its electrical
capability.

2.2 Hardware Installation

1. Place the Camera on the ceiling or fix it onto wall:
Use three screws to fix the camera onto the ceiling or wall.
2. Plug an Ethernet cable into the camera:
Connect the Ethernet cable (not included in the package) to the LAN socket. It is
recommended to use exterior-grade Ethernet cable that is already waterproof.
The all-in-one cable is waterproof except its rear end where there is a yellow
warning sticker, stating it is not waterproof.
3. Check the LED indication
As the camera adopts the IEEE 802.3af standard, its Ethernet cable can be connected to a
PoE switch to obtain power.
Once IP camera is properly installed and powered on, the power LED will be lit in orange,
meaning the system is booting up successfully. Furthermore, if you have a proper network
connection, and access to the camera, the LAN LED will flash green.
The power supplied to the camera is supported via a PoE switch or DC adapter.
However, the DC adapter is unnecessary when Internet camera is connected to
the PoE switch. Otherwise, the camera may be damaged once it is connected to
the PoE switch and power adapter simultaneously.
4. Adjust the angle of lens:
Adjust the camera's stand to get a proper angle.
5. Adjustment done
H.265 3 Mega-pixel Bullet IR IP Camera with Remote Focus and Zoom
18
ICA-M3380P