I/O Control Instruction; Hardware Installation; Connector Board - Planet ICA-5150 User Manual

2.1.2 I/O Control Instruction

Descriptions for I/O cable set:
Interface
DC Power Jack
Ethernet

2.2 Hardware Installation

2.2.1 Connector board

1. Please select the most suitable position on the ceiling to install this camera.
2. Use the provided L-wrench, loosen the tamper-resistant housing cover (with screws
still attached on the cover). The unit has a factory installed side conduit entry and one
may adjust the cables to back conduit entry according to installation requirement.
password (admin).
Restoring the factory default setting will lose all the
previous settings including IP address. User needs to run
the IPWizard II program to search the device and configure
it to let the device work properly again.
The input power is 12V DC.
Use the power adapter included in the package for
the camera. Otherwise, an improper power
adapter may damage the unit and result in danger.
The LAN socket is an RJ-45 connector for connection to
10Base-T Ethernet or 100Base-TX Fast Ethernet cabling.
This Ethernet port in the N-Way protocol can detect or
negotiate the transmission speed of the network
automatically. Please use Category 5 cable to connect the
Network Camera to a 100Mbps Fast Ethernet network switch
or hub.
12
Ultra-mini HD Vandal Dome IP Camera
Description
ICA-5150