Installation; Hardware Installation; Software Quick Configuration - Planet ICA-750 User Manual

The followings are instructions for setting up the ICA-750. Refer to the illustration and follow
the simple steps to quickly install.

2.1 Hardware Installation

1. Connect an Ethernet cable
Connect one end of an Ethernet cable to the LAN port located on the camera's rear panel
and connect the other end to the network device (hub or switch).
2. Attach the external power supply
Attach the provided power adapter to the camera's connector labeled "PWR" on the rear
panel.
3. Check the LEDs
a. The Power LED will turn on briefly, and then start blinking during startup. After startup is
completed, the Power LED will remain ON.
b. The LAN LED will be ON.

2.2 Software Quick Configuration

Initial setup should be performed by using the supplied Windows-based Setup Wizard as
follows:
1. Insert the bundled product CD into CD-Rom drive to launch the autorun program.
2. After the CD's menu displaying, click the "Setup Wizard" hyperlink on the menu to start
the configuration process.
Note:
If the CD's menu does not appear, click "Start" on the task bar and select "Run" to type "X:\Utility\
SetupWizard \SetupWizard.exe", assume X is your CD-Rom drive.
12

2. Installation

ICA-750 User Guide