Adjustment; Packaging, Transport And Storage - Vega VEGAWELL 52 Operating Instructions Manual

Voltage supply
Packaging
Transport
Transport inspection
VEGAWELL 52 • 4 ... 20 mA/HART
Fig. 3: Front-flush installation of the CERTEC
1 Housing, sensor
2 Measuring cell
3 Lateral seal for measuring cell
4 Additional, front seal for measuring cell
5 Diaphragm
4 ... 20 mA/HART two-wire electronics for voltage supply and meas-
ured value transmission on the same cable.
The data for power supply are specified in chapter "Technical data".
3.3

Adjustment

The instrument can be adjusted with the following adjustment media:
•
With the external display and adjustment instrument VEGADIS 82
•
An adjustment software according to FDT/DTM standard, e.g.
PACTware and PC
•
With a HART handheld
The type of adjustment and the adjustment options depend on the
selected adjustment component. The entered parameters are gener-
ally saved in the respective sensor, when adjusting with PACTware™
and PC optionally also in the PC.
3.4

Packaging, transport and storage

Your instrument was protected by packaging during transport. Its
capacity to handle normal loads during transport is assured by a test
based on ISO 4180.
The packaging of standard instruments consists of environment-
friendly, recyclable cardboard. For special versions, PE foam or PE
foil is also used. Dispose of the packaging material via specialised
recycling companies.
Transport must be carried out in due consideration of the notes on the
transport packaging. Nonobservance of these instructions can cause
damage to the device.
The delivery must be checked for completeness and possible transit
damage immediately at receipt. Ascertained transit damage or con-
cealed defects must be appropriately dealt with.
3 Product description
1
2
3
4
5
measuring cell with double seal
®
9