Supplement; Technical Data - Vega VEGAWELL 52 Operating Instructions Manual

10 Supplement

10 Supplement

10.1 Technical data

Note for approved instruments
The technical data in the respective safety instructions are valid for approved instruments (e.g. with
Ex approval). These data can differ from the data listed herein, for example regarding the process
conditions or the voltage supply.
General data
Measured variable
Measuring principle
Communication interface
Materials and weights
Materials, wetted parts
Ʋ Transmitter
Ʋ Protective cap
Ʋ Diaphragm
Ʋ Joining material, diaphragm/base ele-
ment of measuring cell
Ʋ Measuring cell seal - single
Ʋ Measuring cell seal - double
Ʋ Suspension cable
Ʋ Cable gland on the transmitter
Ʋ Cable seal with PE, PUR cable
Ʋ Cable seal with FEP cable
Ʋ Process fitting
Ʋ Straining clamp
Ʋ Unassembled screw connection
Ʋ Threaded connection on the housing
Materials, non-wetted parts
Ʋ Housing
Ʋ Type label support on cable
Materials, transmitter protection
Transport and mounting protection,
transmitter
transport protection net
Ohmic contact
Weight approx.
Ʋ Basic weight
Ʋ Suspension cable
30
Level
Ceramic-capacitive, dry measuring cell
HART signal on 4 ... 20 mA cable
Titanium
PA, PE
Sapphire ceramic (99.9 % oxide ceramic)
®
Glass solder
FKM (VP2/A), EPDM (A+P 75.5/KW75F)
FKM (VP2/A)+FKM (VP2/A), EPDM (A+P 75.5/
KW75F)+EPDM (A+P 75.5/KW75F)
PE (FDA and KTW-approved), FEP, PUR
316L
FKM
FEP
316L
316L
316L
316L
plastic PBT (Polyester), 316L
PE hard
PA
PE
Between ground terminal, metallic process fitting and
transmitter
0.8 kg (1.764 lbs)
0.1 kg/m (0.07 lbs/ft)
VEGAWELL 52 • 4 ... 20 mA/HART