Panasonic AK-HCU3550EA Operating Instructions Manual page 60

8. Setting of menu items
Mode
This menu is used for the Mode settings.
When the cursor is brought to the "Mode" menu title and the
jog dial is pressed, the display returns to the Maintenance
menu at the next hierarchical level above.
> Mode >
Iris Scale
WFM Select
p Iris Scale: Iris scale setting
Use this to select the range of the iris display to be shown
on the status display screen.
Selection options: FULL, 2STOP
p WFM Select:
Selection of waveform monitor to be connected
Select this to set the type of waveform monitor (WFM) to
be connected to the WFM CONT/AUX connector.
Selection options: TYPE A, TYPE B, TYPE C
Initial value: TYPE C
Setting Control mode
TYPE A Coded mode
TYPE B Direct mode
TYPE C For staircase control
) There are three types of waveform monitors (WFM)
which can be connected.
) The waveform monitor's preset can be recalled by
operating the MONITOR switch on the ROP.
These presets must be set ahead of time at the
waveform monitor.
Depending on the monitor model used, a specially
designated cable is required to connect the unit to the
waveform monitor.
Correlation between the MONITOR switches on the
ROP and waveform monitor preset numbers
The waveform display settings of the waveform monitor
are read using the preset function of the waveform
monitor.
MONITOR switch
on ROP
R
B
G
R+B+G
R+B
R+G
B+G
SEQ
ENC
) For details on the control that corresponds to the
preset numbers which were set for the waveform
monitor, consult with your dealer.
FULL
TYPE C
Waveform monitor
preset number
Preset 1 (R)
Preset 2 (B)
Preset 3 (G)
Preset 4 (Super)
Preset 5 (Sequence)
ENC (TYPE C only)
Be sure to ask your dealer to carry out the operations described in
this chapter for you.
Analog Gain
This menu is used to set the analogue signal levels.
When the cursor is brought to the "Analog Gain" menu
title and the jog dial is pressed, the display returns to the
Maintenance menu at the next hierarchical level above.
> Analog Gain >
Composite1
Composite2/PM
WFM
Q Gain
I Gain
Burst Gain
Stair Gain
Stair Bal
p Composite1:
Composite 1 video gain setting
Select this to set the video level of the analogue
composite signal 1 to be output from the ANA
COMPOSITE OUT 1 connector.
Selection options: –50 to 50
p Composite2/PM:
Composite 2/PM video gain setting
Select this to set the video level of the analogue
composite signal 2 to be output from the ANA
COMPOSITE OUT 2/PM connector.
Selection options: –50 to 50
p WFM:
Waveform monitor video gain setting
Select this to set the video level of the analogue
composite signal to be output from the WFM OUT
connector.
Selection options: –50 to 50
60
0
0
0
0
0
0
0
0