Mode; Iris Scale; Wfm Select - Panasonic AK-HCU3550EA Operating Instructions Manual

5. Web settings

Mode

This is the mode setting screen.
p Iris Scale: Iris scale setting
Use this to select the range of the iris display to be shown
on the status display screen.
Selection options: FULL, 2STOP
p WFM Select:
Selection of waveform monitor to be connected
Select this to set the type of waveform monitor (WFM) to
be connected to the WFM CONT/AUX connector.
Selection options: TYPE A, TYPE B, TYPE C
Initial value: TYPE C
Setting Control mode
TYPE A Coded mode
TYPE B Direct mode
TYPE C For staircase control
) There are three types of waveform monitors (WFM)
which can be connected.
) The waveform monitor's preset can be recalled by
operating the MONITOR switch on the ROP.
These presets must be set ahead of time at the
waveform monitor.
Depending on the monitor model used, a specially
designated cable is required to connect the unit to the
waveform monitor.
Correlation between the MONITOR switches on the
ROP and waveform monitor preset numbers
The waveform display settings of the waveform monitor
are read using the preset function of the waveform
monitor.
MONITOR switch on
ROP
R
B
G
R+B+G
R+B
R+G
B+G
SEQ
ENC
) For details on the control that corresponds to the
preset numbers which were set for the waveform
monitor, consult with your dealer.
38
Waveform monitor
preset number
Preset 1 (R)
Preset 2 (B)
Preset 3 (G)
Preset 4 (Super)
Preset 5 (Sequence)
ENC (TYPE C only)