LifeSpan Bullet Owner's Manual page 8

STEP 2
1. Consider an additional person to assist by holding the Display Support (F). Connect the Middle Cables
from Right Post Assembly (B) with Upper Cables from Display Support (F). Remove cable ties.
2. Slide Right Post Upper Cover (C) onto Right Post Assembly (B):
3. Attach Display Support (F) onto Right Post Assembly (B) in the following order.
a. Insert inside Allen bolt M8*15 (3) and Inner Tooth Lock Washer (5) loosely
b. Insert rear Allen bolt M8*15 (3) and Inner Tooth Lock Washer (5) loosely
c. Insert outside Allen bolt M8*15 (3) and Inner Tooth Lock Washer (5) loosely
4. Repeat steps 2 to 3 for left hand side. Then tighten all loose bolts on Page 7 and above steps.
5. Attach the L&R Post Upper Covers (C) onto the Display Support (F) with PH Truss ST Screw (4).
4
8
F
1
3a
3 x 3
5 x 3
C
4 x 4
B
BULLET
3b
3c
2