LifeSpan Bullet Owner's Manual page 29

9a. Release the clip back into its position.
10. Check that the motor brush is held firmly in place
by the clip, and that the lead is plugged securely onto
the terminal.
12. You have now successfully replaced the motor brushes. We also recommend that you remove any dirt and
dust from your treadmill motor fan using a vacuum cleaner before replacing the cover.
9b. If your motor uses a push clip, replace the push
clip by pushing it inwards and then down so that it
engages the catch.
11. Replace the motor cover. Repeat steps 1-15 for
the second brush located on the opposing side of the
motor.
29
BULLET