5
C H A P T E R
Storage Devices
This chapter describes how to remove and install the removable media bay, tape
drive, DVD drive, SCC reader, and hard disk drives. It contains the following topics:
Section 5.1, "Hard Disk Drives" on page 5-1
I
Section 5.2, "Removable Media Module" on page 5-6
I
Section 5.3, "Tape Drive" on page 5-11
I
Section 5.4, "DVD-ROM Drive" on page 5-15
I
Section 5.5, "DVD-ROM Backplane" on page 5-17
I
Section 5.6, "SCC Reader" on page 5-19
I
You can remove and install the hard disk drives without powering off the system. To
remove the removable media drives and bay, you must power off the system.
5.1
Hard Disk Drives
Caution – Use proper ESD grounding techniques when handling components. Wear
!
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
The hard disk drives, HDD0 and HDD1, are located at the right front of the system
(
FIGURE 5-1
).
5-1