Structure Of The Input/Output Data - Fluke endurance series User Manual

Endurance® Series
Users Manual
Color mode
Slope
Emissivity
Transmissivity
Sensor offset
Sensor gain
Averaging time
Valley hold time
Peak hold time
Setpoint relay
Deadband
Decay rate
Relay alarm output control
Laser control
Panel lock
Analog output mode
Bottom temperature of output
Top temperature of output
8.6.3.2. Profinet alarm behavior
Parameter
Message diagnostics alarm
Message process alarm
Behavior on module fault

8.6.4. Structure of the input/output data

8.6.4.1. Pyrometer module input data
The input data length is 23 Byte.
Address
Length
without offset
0 4 Byte
4 4 Byte
8 4 Byte
12 4 Byte
16 4 Byte
20 1 Byte
21 2 Byte
48
* 1000 (0.9  900)
* 1000 (0.9  900)
* 1000 (1.0  1000)
* 0.1s (1s  10)
* 0.1s (1s  10)
* 0.1s (1s  10)
in °C /°F
Set output mode
Set bottom temperature of
analog output
Set top temperature of analog
output
Description
The diagnostics information of
pyrometer is not transferred to
the PROFINET IO controller
is transferred to the PROFINET
IO controller
The process alarm of pyrometer
is not transferred to the
PROFINET IO controller
is transferred to the PROFINET
IO controller
Format
REAL (Big Endian, Motorola)
REAL (Big Endian, Motorola)
REAL (Big Endian, Motorola)
REAL (Big Endian, Motorola)
DWORD
BYTE Bit0 (Bool)
INT(Big Endian, Motorola)
Fahrenheit
1 , 2 color
850 ... 1150
100 ... 1100
100 ... 1100
-200 ... +200
800 ... 1200
0 ...3000
0 ...3000
0 ...3000
dev. range min.. max
1 ...99
0 ...9999
normally open,
normally closed,
permanently open,
permanently closed.
off / on / flashing/ trigger
locked / unlocked
0 ... 20 mA / 4 ... 20 mA
0...9999°C /°F
0...9999°C /°F
Setting
message inactive
message active
message inactive
message active
set process data to zero,
set process data to last value
Value
Target Temperature 2 color
Target Temperature 1 color wide
Target Temperature 1 color narrow
Internal temperature
Error Code
Trigger state ( 0 – reset, 1 – set)
Measured attenuation