Table of Contents
Advertisement
No.
4
5
6
When the network is connected, the "S" LED is solid yellow, while the "L"
7
8
Press RESET button about 10s when the camera is powering on or rebooting to restore the default
settings, including the user name, password, IP address, port No., etc.
3.2.2 Installation
Steps:
1. (Optional) Use a plier to remove the clip (marked in dotted line in 0) on the side of the back box
and then route the cables through the opening instead of the cable hole.
2. Loosen the set screws with a hex key (supplied) to remove the cover.
Installation Manual of Network Camera
Description
Set screw hole
Set screw of lens
S & L: Network status indicator.
LED flashes orange.
RESET Button
Figure 3-17 Side Clip
28
Base plate
Advertisement
Table of Contents
