Mira Gem 88 Installation & User Manual page 27

2.3 Fit the shower control to the support
bracket with the screws, nuts and
washers supplied.
Fix the support bracket and shower
control in position using suitable fixing
(not supplied).
Note! The support bracket requires a
clearance depth of 60 mm, with a wall
thickness of 4 mm. Wall thicknesses
in excess
accommodated, but clearance will be
required around the inlet and outlet
connections to allow insertion of pipe
and tightening of compression nuts.
The raised portion on the building-in
shroud can be used as a depth gauge,
to allow a finished wall thickness
between 4 and 21 mm.
2.4 Drill and suitably plug the four marked
fixing holes.
2.5 Secure the support bracket to the wall
with the screws and plugs provided.
2.6 Follow the shower control installation
procedure as for "Solid or dry-lined
wall structures": instructions 1.4 to
1.17 inclusive to complete the
installation.
of 4mm can be
4 - 21 mm
Nuts
Washers
Retaining Screws
27
4 mm
60 mm
Clearance to
allow pipe
insertion
Support Bracket