Mira Gem 88 Installation & User Manual page 18

1.10 Thoroughly flush the incoming hot
and cold water supply pipes before
connecting the shower control.
1.11 Fit the compression nuts and olives
over the supply pipes and then make
the connection to the inlet pipework.
Make sure that you protect the plated
surfaces.
1.12 Turn on the water supplies to the
shower mixer and check for any leaks.
1.13 Turn the flow lever 1/4 of a full turn
anticlockwise for water flow. Operate
temperature knob and make sure that
the directional hot and cold indicators
are correct.
HOT = anticlockwise
COLD = clockwise
Note! If this is not the case, refer to
section: Reversed inlets.
Turn flow lever fully clockwise to stop
water flow.
1.14 This completes the installation of the
Mira Gem 88 for connection to rising
and falling inlet supplies.
Compression Nut
Temperature Knob
18
Olive
Nipple
Flow lever