Mira Gem 88 Installation & User Manual page 20

2.6 Loosen the backplate grub screw and
using the 2.5 mm A/F hexagonal
wrench provided, remove the
backplate from the shower control
body.
2.7 Drill and suitably plug the two fixing
holes. Secure the backplate to the wall
by means of the screws provided.
2.8 Fit the concealing plates over the
pipework into the enlarged recess in
the finished wall surface.
2.9 Thoroughly flush the incoming hot
and cold water supply pipes before
connecting the shower control.
2.10 Fit the compression nuts and olives
to the supply pipes.
2.11 Align the valve over the backplate and
inlet pipe work. If the pipe work and
the nipples are not aligned, the nipples
can be moved to achieve the
alignment. This adjustment can
achieve an alignment of the pipes
centre between 149 - 154 mm.
2.12 Locate the shower control body onto
the backplate and secure by tightening
the grub screw using the 2.5 mm A/F
hexagonal wrench (supplied).
Make the connections to the inlet
pipework. Protect the chrome plated
surfaces when tightening the
compression nuts.
Concealing Plate
20
Supply Pipe
Compression Nut
Olive