Shower Cubicle Or Laminated Panel - Mira Gem 88 Installation & User Manual

3. Shower cubicle or laminated panel

The support bracket (optional) is recommended to fit the shower control into a shower
cubicle or laminated panel 2 - 20 mm thick.
The dimension from the bracket to the finished wall surface is 50 - 68 mm.
3.1 Cut a 108 mm diameter hole in the
panel and drill two 4.5 mm holes at
138 mm centres at an angle of 45
the horizontal.
3.2 Remove the plastic building-in shroud.
The two building-in shroud retaining
screws should be screwed temporarily
into the backplate for use later.
Note! Do not remove the Body
Shroud or Seal. If the cavity seal or
shroud have been removed or are
incorrectly fitted, refer to section:
'Refitting the Cavity Seal'.
°
from
108 mm
Backplate
Cavity
Seal
Retaining Screws
28
2 to 20 mm
50 to 68 mm
Ø 4.5 mm
o
45
Body
Shroud
Building-in Shroud
Finished
Wall Surface
Panel
Fixing
Screw
Cubicle or
Laminated
Panel