Mira Gem 88 Installation & User Manual page 25

1.13 Lock the flow control lever in position
by pushing the grey indicator trim
bearing over the cartridge. The four
clips on the inner edge of the grey
indicator trim bearing should clip into
the four cut outs in the cartridge.
Note! Make sure that the larger of the
four clips is fitted at the bottom.
Tip! Fit the bottom clip first.
1.14 Locate the indicator trim over the
splines of the cartridge. Make sure that
the colour temperature graphics are at
the top with cold in the clockwise
position.
1.15 Make sure that the temperature knob
is correctly aligned and push into
position until it clicks.
1.16 Install the shower fittings (refer to
separate installation guide).
1.17 Turn the flow lever 1/4 of a turn
anticlockwise for water flow.
Operate the temperature knob and
make sure directional hot and cold
indicators are correct.
HOT = anticlockwise
COLD=clockwise
Note! If this is not the case refer to
section: 'Reversed inlets'.
Turn flow knob fully clockwise to stop
water flow.
1.18 This completes the installation of the
Mira Gem 88 B into solid or dry-lined
wall structures.
Grey Indicator
Trim Bearing
Cut Outs
For Clips
Hot
25
Note! Make sure
that the large clip
is at the bottom
Flow Control
Lever
Cold
Indicator Trim
Temperature Knob
Clips