Lancom L-305agn Wireless Manual page 33

LANCOM L-300 Access Point Serie
Chapter 2: Installation
LAN interface: Can be used exclusively or in parallel for DSLoL.
There are basically two possibilities for using the access point for DSLoL operation. Use exclu-
sive mode when you wish to connect the device directly to the DSL modem. Use automatic
mode when you wish to connect it to a hub or switch on a wired LAN and the hub (or switch)
is connected to the DSL modem. If the access point is advertised as a gateway via DHCP, com-
puters in the LAN and wireless LAN can
access the Internet via one physical port
simultaneously. You can set the desired
mode in LANconfig in the interface set-
tings of the DSLoL interface.
DSLoL supports all PPPoE-based

Internet connections (such as T-DSL) as well as Internet connections that have been
implemented with static IP addresses via a router (for example CompanyConnect or
various SDSL connections for business customers).

32
DSLoL – if you wish to operate the access point in DSLoL mode you can
either connect the device directly to the DSL modem (exclusive mode) or
via a hub or switch in the wired LAN (automatic mode).
In exclusive mode, plug one end of the network cable supplied (green
connectors) into the LAN port of device
the corresponding port on the DSL modem.
In automatic mode, plug one end of the supplied network cable
(green connectors) to the LAN port on device
into an available network connector socket in your local network (or
a free socket on a switch or hub).
Power supply – socket
vided.
Alternatively you can use the PoE facility for the power supply (please refer
→
to 'Power over Ethernet—elegant power supply over LAN cabling').
Please make sure to use only the power adapter listed in the technical
specifications. The use of the wrong power adapter can be of danger
to the device or persons.
»
and plug the other end into
is for connecting the power supply unit pro-
»
and the other end