Lancom L-305agn Wireless Manual page 28

The following can be displayed for WLAN data:
Green
Red
Red
ETH LAN connector status:
Off
Green
Green
Messages via the WiFi Protected Setup (WPS). This function is not yet available
WPS
with early shipments. Please download the latest firmware and the associated
user manual from www.lancom.de.
Device con- LANCOM L-305agn Wireless and LANCOM L-310agn Wireless
nectors
The rear panel accommodates the L-300 Access Point's connectors. The
models LANCOM L-305agn Wireless and LANCOM L-310agn Wireless are
equipped with the following connectors:
Device example:
LANCOM L-310agn
Wireless
³
LANCOM L-310agn
Wireless only
·
»
Flickering
Flickering
Blinking
On (perma-
nently)
Flickering
Ant 1
·
³
Connector for the first external antenna
Connector for the supplied power adapter
Ethernet socket ( 10/100/1000Base-Tx) for connection to the LAN.
The available transfer rate is detected automatically (autosensing).
The LAN connectors support the Power over Ethernet standard (PoE).
Further information about the operations with PoE can be found in the
→
information box 'Power over Ethernet—elegant power supply over
LAN cabling'.
LANCOM L-300 Access Point Serie
TX data traffic.
Error in wireless LAN (TX error, e.g. transmission error
due to a poor connection)
Hardware error in the WLAN module
No networking device attached
Connection to network device operational, not data traffic
Data traffic
Ant 2
ETH Config (COM)
»
¿ ´
Chapter 2: Installation
Ant 3
Reset WPS
² ¶ º
27