Lancom L-305agn Wireless Manual page 27

LANCOM L-300 Access Point Serie
Chapter 2: Installation
The power LED is blinking and no connection can be
made?
If the power LED blinks red and no WAN connections can be
established, there is no cause for concern. This merely means
that a pre-set charge or time limit has been reached.
There are three ways to remove the lock:
Reset the toll protection.
Increase the limit.
Deactivate the lock completely (set limit to '0').
LANmonitor shows you when a charge or time limit has been reached. To reset the toll protec-
tion, activate the context menu (right-mouse click) Reset charge and time limits. The charge
settings are defined in LANconfig under Management
lable if the 'Complete configuration display' is activated under Tools
With WEBconfig, resetting the toll protection and all parameters are found under Expert con-
figuration Setup
WLAN Link
Provides information about the WLAN connections via the internal WLAN
module.
The following can be displayed for WLAN link:
Off
Green
Green
Green
Red
Provides information about the data traffic at the internal WLAN module.
WLAN Data
26
Charges.
Inverse flashing
Blinking
Blinking
Costs (these settings are only avai-
No WLAN network defined or WLAN module deactiva-
ted. The WLAN module is not transmitting beacons.
At least one WLAN network is defined and WLAN
module activated. The WLAN module is transmitting
beacons.
Number of flashes = number of connected WLAN stati-
ons and P2P wireless connections, followed by a pause
(default).
Alternatively, the frequency of the flashed can indicate
the input sensitivity.
DFS scanning or other scan procedure.
Hardware error in the WLAN module
Signal that a
charge or time
limit has been
reached
Options).